Instructions / Assembly

QuickJack™ Portable Car Jack 40 P/N 5900263 — Rev. B1 — September 2021
If the Lock Bar Bolt is too tight, it does not allow the Lock Bar to move freely in the Lock Channel.
This is a safety issue ; the QuickJack locks cannot be engaged unless each Lock Bar is
moving freely in its Lock Channel. If the Lock Bar moves up with the Vehicle as it is raised (as
shown above on the right), it cannot lock.
⚠ WARNING The Lock Bar must be moving freely in the Lock Channel. If it is not, the QuickJack
cannot be put into a safe, locked position.
To fix an overtight Lock Bar Bolt, loosen the Lock Bar Bolt until the Lock Bar moves freely and
stays in the Lock Channel (as shown above, on the left).
7. Walk around the Vehicle and the QuickJack Frames; make sure everything is set up correctly.
8. Press and hold Up on the Pendant Control.
9. Just
before the Frames make contact with the Vehicle, release Up. The Frames stop moving.
10. Check the locations where the Lift Blocks will hit the factory-recommended Lifting Points on the
Vehicle. If necessary, adjust the Lift Blocks so that they are properly positioned (you may need to
lower the Vehicle some to adjust the Lift Blocks).
11. Make sure both Lock Bars are moving freely in their respective Lock Channels.
12. After confirming the Lift Blocks and Lock Bars are properly positioned, press Up.
The QuickJack Frames start going up and the Lift Blocks hit the Vehicle’s Lifting Points.
⚠ WARNING Do not stop raising the Frames until you have passed the First Locking Position.
13. Make sure all Lift Blocks are still in contact with the factory-recommended Lifting Points.
If the Lift Blocks
are in the right positions, continue with raising the QuickJack Frames.
If the Lift Blocks are
not in the right positions, press Down on the Pendant Control and carefully
return the Vehicle to the ground, then make the necessary adjustments.
14. To engage the QuickJack on a Locking Position, release Up and then press Down to lower the
Frames until they lock.
The following drawing shows the Frame securely engaged on a locking position.
Not to scale. Not all components shown. Shows Release Cam and Lock Bar in Locked Position.