Instructions / Assembly

QuickJack™ Portable Car Jack 32 P/N 5900263 — Rev. B1 — September 2021
5. If a Frame is not stable, adjust the Lift Blocks and/or the QuickJack Frame until it is stable.
Do not proceed until both QuickJack Frames are stable on the stacked Lift
Blocks.
6. Using the Pendant Control, raise and then lower both Frames about 8 in / 203 mm or so off the
ground (do not pass the First Locking Position)
three times .
Note: Without the weight of a Vehicle on them, the QuickJack Frames may lower unevenly and
slower than normal.
Raising and lowering the Frames moves Hydraulic Fluid into the Hydraulic System and pushes air
towards the Bleeder Screws.
7. Put a clean rag under the Bleeder Screw on the Hydraulic Cylinder you are going to bleed first.
There is definitely going to be Hydraulic Fluid coming out, so it is better to be ready for it.
8. Loosen the Bleeder Screw using the hex key.
9. When you hear air escaping, stop loosening the Bleeder Screw—air and some Hydraulic Fluid
come out.
⚠ WARNING You must wear OSHA-approved (publication 3151) Personal Protective Equipment
at all times when handling hydraulic components: eye protection and leather
gloves are mandatory.
10. When no more
air is coming out, tighten the Bleeder Screw and wipe up the Hydraulic Fluid.
11. Put another rag under the Bleeder Screw.
12. Press Up on the Pendant Control for a couple of seconds, then stop.
This helps to move any remaining air towards the Bleeder Screw.
13. Open the Bleeder Screw a small amount.
14. Press Up on the Pendant Control for a couple of seconds only, then stop.
A combination of air and Hydraulic Fluid comes out.
15. Tighten the Bleeder Screw.
The Bleeder Screw must be tightened before you press Down on the Pendant Control. If it is not
tightened, air will be pulled
in as the QuickJack Frames lower.
16. Press Down on the Pendant Control; return the QuickJack Frames to flat.
Note: Without the weight of a Vehicle on them, the QuickJack Frames may lower unevenly and
slower than normal.
17. Repeat Steps 13 through 16 until no more air comes out.
18. Clean up any remaining Hydraulic Fluid.
19. Tighten the Bleeder Screw with the hex key:
do not overtighten.
20. Lift one of the QuickJack Frames, remove the stacked Lift Blocks, lower the frame back down to
the ground, and then repeat for the other QuickJack Frame.