Instructions / Assembly

QuickJack™ Portable Car Jack 24 P/N 5900263 — Rev. B1 — September 2021
About Quick-Connect Fittings
Quick-Connect Fittings let you quickly connect and disconnect the QuickJack’s Hydraulic Hoses.
To lock a connection: Push the Male Quick-Connect Fitting into the Female Quick-Connect Fitting,
then turn the Moveable Section so that the Lock Ball is not opposite the Notch.
To
unlock and disconnect a connection: Turn the Moveable Section so the Lock Ball is
opposite the Notch, then pull back on the Moveable Section and pull out the Male Quick-Connect
Fitting.
Preparing and Connecting the Long Hydraulic Hoses
To connect the Long Hydraulic Hoses, you will need from Box 3:
• Two Long Hydraulic Hoses (5570216).
• Four Female Quick-Connect Fittings (5550031).
The following graphic shows the connections to make to the Long Hydraulic Hoses.
To prepare and connect the Long Hydraulic Hoses:
1. Locate both Long Hydraulic Hoses and remove their protective caps.
2. Prepare the Threaded ends with the supplied Thread Sealant.
3. Connect the Female Quick-Connect Fittings to the male threaded connectors on both ends of both
Long Hydraulic Hoses.
To tighten, use one wrench to hold the Male connector in place and a second wrench on the
Female Quick-Connect Fitting to tighten it; make 2-3 full turns using a wrench to securely tighten in
place.
4. Connect one end of the Long Hydraulic Hose to the Short Hydraulic Hose; the other end of the
Long Hydraulic Hose connects to the Power Unit; do the same for the other Long Hydraulic Hose
and Short Hydraulic Hose.