Owner`s manual

Quickie SALSA 19
ENGLISH
do not injure your legs when legrests are extended.
WARNING - Always ensure that the legrests or footplates do not
come into contact with the castors before driving the wheelchair.
WARNING - Legrests are not to be used for lifting or carrying the
wheelchair with an occupant.
5.9.1 Fitting legrest
Offer the legrest assembly at right angles to the frame (Fig. 51),
locate the stem into the legrest and swing the assembly forward
to lock in position. To swing away the footrest, depress
the retaining catch and turn the footrest out. This can
now be lifted out if required, (Fig. 50).
5.9.2
Footplates
The footplates may be
flipped up to aid entry and exit
from the chair.
WARNING - Do not use the footplates to stand on as the full
weight of your body may cause the chair to tip forwards. This
could result in injury and could damage the footrests.
5.9.3 Adjusting the footrest length
To adjust the footrest length remove the screw assembly on the
footrest stem as shown in (Fig. 52), adjust the length to suit.
Ensure the bolts are firmly located and tighten ed prior to use.
Note: The internal footrest stem may require cutting down in
length to allow the footplate position to be raised.
5.9.4 Hanger depth adjustment (Fig. 53 - 55)
1. Remove both sets of 5mm hanger depth adjustment bolts.
2. Slide both hanger receivers to the desired location. See bolt
pattern seat depth position settings (B)
3. Replace both sets of depth adjustment bolts. (Use 20 N/m
or 177 in/lb of torque.)
Fig. 50
Fig. 51
Screws
Fig. 52
Fig. 53
Fig. 54
Fig. 55