Owner`s manual

Quickie SALSA 17
ENGLISH
8. Replace the armrest pivot bolts on both sides of the seat.
Do not tighten completely. (Fig.39)
PART II: ARMPAD ANGLE ADJUSTMENT
9. Loosen the 4mm armpad angle pivot bolts (A) on both
armrests. Remove the 4mm angle index bolts (B) on both
armrests.
10. Use the 5mm fine height adjustment screw (C) to finish fine
tuning the height. Turn counter-clockwise to increase height or
clockwise to lower.
11. Tilt both armpads down (or up in the case of a lowered
armrest) until the armpads are in the preferred angle. Check
to see if the height is correct. (Refer to Number 10 for further
height adjustment.)
12. Retighten both armrest pivot bolts. (Use 20 N/m or 177 in/lb
of torque.)
13. Retighten both armpad angle pivot bolts (A). Replace both
armpad angle index bolts (B). (Use 10 N/m or 88.5 in/lb of torque
for both sets of bolts.)
Fig. 36
Fig. 37
Fig. 38
Fig. 39
Fig. 40
Fig. 41
Fig. 42
Fig. 43