Specifications

38 Quickie Rumba
Ref: P19093
Seat width adjustment (Fig. 10.3):
To adjust the width between the armrests, use a size 10
mm hexagonal wrench to loosen the hexagonal screws
on the armrest adapter retainers, which are located on
the side frame below the armrests, and pull the armrests
outwards or inwards to achieve the desired position.
Tighten the screws securely. Make sure that the screws
are secured with the locking-nuts.
10.3 Seat depth adjustments:
(Rumba Modular only, (Fig. 10.4). To adjust the seat depth
remove the 2 bolts on each side of the frame. Move the
backrest into the seat depth position required. Put the bolts
back and tighten them up. If you need to compensate the
armrest position to the depth adjustment you have a dual
armrest receiver bracket to insert the side-guard (Fig.
10.2).
Fig. 10.4
Seat Depth Bolts
10.0mm
Screw
Fig. 10.3
10.0 Adjustments:
10.1 Adjustment of the footrest (Fig. 10.1):
To adjust the height of a footrest:
Loosen the screw, using a cross-head screw driver and
set the footrest at the height desired, then tighten the
screw in the hole.
NOTE: Make sure that the screws are tightened securely.
10.2 Adjustment of the armrests:
Height adjustment (Fig. 10.2):
Set the screw in the hole of the armrest tube that
corresponds with the desired height. Turn the handle
clockwise to tighten.
Screw on
Inside
Handle
Fig. 10.2
Fig. 10.1