System information

HULA 21
Rev.1.0
PART 2
Loosen the 4mm arm pad angle pivot bolts (A) on both
armrests. Remove the 4mm angle index bolts (B) on both
armrests, (Fig.5.24).
Use the 5mm fine height adjustment screw (B) to finish
fine tuning the height. Turn counter-clockwise to increase
height or clockwise to lower, (Fig.5.25).
Tilt both arm pads down, (or up in the case of a lowered
armrest), until the arm pads are in the preferred angle.
Check to see if the height is correct, (Fig.5.26).
Refer to 2 for fine adjustment.
Retighten both armrest pivot bolts to Use 20 Nm or
177lbf/in of torque. (Fig.5.27).
Retighten both arm pad angle pivot bolts “A”. Replace both
arm pad angle index bolts “B” to 10 Nm or 88.5lbf/in of
torque for both sets of bolts, (Fig.5.28).
Fig. 5.24
Fig. 5.25
Fig. 5.26
Fig. 5.27
Fig. 5.28