Specifications

DATA SHEET QF4A512
Rev D4, Dec 07 39 www.quickfiltertech.com
Description: Indicates PLL lock status.
ism_pll_lock – AUTO SET, may be reset by user
* 0 = Not locked.
1 = Locked.
Description: Indicates initialization lock status.
0Dh EE_VAL (EEPROM Status Register Value) – READ ONLY
Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
Address 0Dh D7 D6 D5 D4 D3 D2 D1 D0
Description: Value of the EEPROM Status register. Default value = 0 at powerup.
0Eh EE_STATUS (EEPROM Status Flags) – Bits are autoset by the chip, can only be reset by the user
Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
Address 0Eh igc_done_xtdinit igc_done_ism wr_full_done rd_full_done spim_eebusy spim_eestat spim_wr_done spim_rd_done
Default value= 00h.
These flags can only be set by the chip. They can only be cleared by writing a zero to the desired location.
spim_rd_done = Read from EEPROM complete.
spim_wr_done = Write to EEPROM complete.
spim_eestat = EEPROM status read complete.
spim_eebusy = EEPROM busy caused abort of attempted read/write.
rd_full_done = Full read from EEPROM complete.
wr_full_done = Full write to EEPROM complete.
igc_done_ism = Initialization sequence complete.
igc_done_xtdinit = Extended initialization sequence complete.
Description: Status flags for data transfers to/from EEPROM.
0Fh ADC_STATUS0 (ADC out of range, high or low) – READ ONLY
Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
Address 0Fh X X X X adc_oo4 adc_oo3 adc_oo2 adc_oo1
adc_00N
* 0 = Within range.
1 = Out of range, high or low.
Description: Indicates an out of range condition for the ADC on channel N.
10h ADC_STATUS1 (ADC out of range, specific) – READ ONLY
Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
Address 10h adc_un4 adc_un3 adc_un2 adc_un1 adc_ov4 adc_ov3 adc_ov2 adc_ov1
adc_ovN
* 0 = No overflow.
1 = ADC overflow, out of range, high.
Description: Indicates an overflow condition for the ADC on channel N.