Specifications

Page 19 of 54
Screen 1 (TCS)
Screen 2 (MOPS)
Screen 3 (SPD)
Screen 4 (TOAD)
atdaemon
TCS
dclocks
MOPS
MOTP
atdrivemon
SPD
Pointings
attest
Depends on which
virtual desktop is
selected in this
window.
TOAD (in browser,
on local machine,
not in a VNC
session)
Table 11 Application distribution in the VNC sessions
Please read the following sections depending on whether you are using a two or
four monitor setup.
If you have not yet set up your VNC connections, refer to 5.6 Setting up your
VNC connections first.
Note that
• blue terminal windows refer to terminals logged into bigrock as user
atcaobs
• green terminal windows refer to terminals logged into MPCCC1 as user
corr
5.5.1. Setup using four monitors
Begin by setting up Screen 2.
• Connect your VNC client to mpvnc1.atnf.csiro.au:11
• Make sure the top left “virtual screen square” says MOPS. If it doesn’t,
click the up or down arrow until it does.
• Right click on the desktop to produce two xterms on MPCCC1 and one on
bigrock
• On the first MPCCC1, start MOPS by executing the command mops
• On the second MPCCC1 terminal, start the total power monitor motp
• In the blue bigrock terminal, start the drive monitor: atdrivemon
Do not send any of those tasks into the background (i.e. do not use ampersand
(&) after the tasks. Terminals only serve a single application startup purpose in
this observing setup).