Datasheet

QUICK-OHM Küpper & Co. GmbH * Postfach 120465 * 42334 Wuppertal
Wuppertal, 06.04.09
Postanschrift: Hausanschrift Telefon: [phone] Handelsregister: Konten:
Postfach 12 04 65 Unterdahl 24 B Telefax: (02 02) 40 43 97 Amtsgericht Wuppertal HRB 4642 Deutsche Bank (BLZ 330 700 90) 5 144 019
D-42334 Wuppertal D-42349 Wuppertal-Cronenberg Telefax: (02 02) 40 43 50 Geschäftsführer: Klaus A. Küpper Postbank Essen (BLZ 360 100 43) 441 83-436
http://www.quick-ohm.de email: [e-mail] Id-Nr. DE 121099121 Stadtsparkasse Wuppertal (BLZ 330 500 00) 214312
Settings overview
Mode (Heating / Cooling, default: Cooling)
Changes the device behavior.
TT offset (-5 °C to +5 °C, default: 0 °C)
Applies a temperature offset to the TT readout of the display.
TA offset (-5 °C to +5 °C, default: 0 °C)
Applies a temperature offset to the TA readout of the display.
Output hyst. (0.1 °C to 5 °C, default: 0.2 °C)
Hysteresis of 0.2 means that the difference between the TA and TT value needs
to be 0.2 °C to let the output change. This prevents the output from jitter.
Output offset (0 °C to 5 °C, default: 0 °C)
Controls the difference between TA and TT before the output is activated.
With its default setting of 0 °C and Heating mode the output is activated when
the temperature (TA) drops below the set point (TT). If a output offset of 5 °C
is used, the output is activated when the temperature (TA) drops 5 °C below
the set point (TT).
Output invert (normal / invert, default: normal)
Normal means if heating or cooling is required the output is set to 1.
Invert means if heating or cooling is required the output is set to 0.
LCD backlight (off / on / timeout 10 to 60 seconds, default: 10 seconds)
Control the lcd backlight. With the default setting of 10 seconds the backlight
gets turned off 10 seconds after the last key was pressed.
LCD contrast (1 to 10, default: 5)
Controls the intensity off the lcd display.
Sw. version Displays the current software version. This setting cannot be changed.