User Manual

26
QNC CHC
EN
INSTALLATION AND USE MANUAL - REV 001A
2.0 - INSTALLATION
• (Fig. 4) Insert the gasket with the adhesive side facing up and apply it to the instrument. Screw the 4 stud bolts to the
fixing bushes.
• (Fig. 5) Fit the instrument in its seat. Insert 4 shaped washers, 4 grower washers and 4 nuts to the stud bolts from
beneath the panel.
2.4 - Instrument installation
SHAPED
WASHER
NUT
GROWER
4 HOLES
Ø 11.5 mm
STUD
Fig. 4 Fig. 5
GASKET
WITH ADHESIVE
SIDE FACING UP
PROTECTIVE
COVER
QNC CHC
At the end of installation, remove the transparent protective film from the instrument surface.
F
If the deck thickness is lower than or equal to 10 mm, the shaped washers must be fitted with flaps facing up. With
thickness greater than 10 mm, the shaped washers must be fitted with flaps facing down.
SHAPED
WASHER
SHAPED
WASHER
≤ 10mm > 10mm
F