QRail Installation

BI 7.2.3-46
Jul-2019, Rev 4.2
27
Mounting Steps, Hidden End Clamps:

A er installation of rails and prior to installation of the modules
slide the Hidden End Clamp into both sides approximately 4
inches from the end of the rail. See Image 6.3.4

Install first module insuring the module frame is flush with the
end of the rails. See Image 6.3.5

Slide Hidden End Clamp over until it fully engages with the
module flange. See Image 6.3.6

Tighten Hidden End Clamp bolt to 9  -lbs (Using Ratchet or
right angel tool). See Image 6.3.7

At end of module row place final module in place (Do not
tighten mid clamps) and mark the edge of the module on the
rail and pick up module.

Cut Rail at the marked location

Replace module and tighten Mid Clamps

Slide final Hidden End Clamp over to fully engage flange of the
module

Tighten Hidden End Clamp Bolt to 9  -lbs (Using ratchet or
right angle tool)

Place End Caps onto rails
Image 6.3.4
Image 6.3.5
Image 6.3.6
Image 6.3.7
NOTE!
The QRail Hidden End Clamp is NOT a bonding solution and
therefore cannot be used on single modules. It must always be
installed in conjunction with at least one Bonding Mid Clamp.