QRail Installation

BI 7.2.3-46
Jul-2019, Rev 4.2
25
6.2 Installing Clamps w/ QClick Technology®
Quick Mount PV’s patented QClick Technology is a special clip with which the module clamps are fastened in the QRail. You
need only a 5mm Allen key for the installation. The QClick is inserted from above into the top channel of the QRail.
Installation Steps:

Insert the QClick at a slight angle into the rail channel.

While holding it firmly in place, rock the QClick upright until it clicks
into place.
Removing the Clamps w/ QClick:
Spreaders on the inside of the QClick are designed so that once the bolt of the
clamp has been tightened, the QClick cannot unlatch from the rail.
To remove a QClick, first unscrew the bolt so that it is clear of the spreaders
then, with pressure on the QClick “legs,” rock the QClick to unlatch it from
the rail and li it out.
Moving the Clamps w/ QClick:
The shape of the QClick corresponds exactly to the profile of the rail
channel. It’s been deliberately designed not to slide easily in order to
prevent unintentional slipping in vertical rail installations. To move the QClick,
loosen the bolt of the clamp so that it is not contacting the spreaders in the
QClick body. Then, while pressing lightly on the bolt, squeeze the QClick legs
together and slide the QClick along the channel.
Image 6.2.1
Installation of clamps w/ QClick Technology
Image 6.2.2
Removing clamps w/ QClick Technology
CAUTION
Material damage caused by deformed QClicks
If clearly deformed QClicks are used, the safety of the module attachment is not assured. PV
modules can fall and be damaged. Use only QClick where the legs are parallel to each other and
you can clearly hear them clicking into the rail channel. Replace the deformed QClick prior to
installation.
QClick Legs
QClick Spreaders
QClick
Clamp bolt
Image 6.2.3
QClick Components
QClick Hooks
DANGER
The outside edge of the
QClick must be installed
at least " from end or
rail at a splice location.