Rail Cutting Guide Instructions

BI 7.2.3-51 Jun-2020, Rev 2
Slide appropriatly sized Standard or Light QRail Rail Cutting Guide
onto the rail and push guide flush to the module edge. The bent lip
on the Rail Cutting Guide should be positioned ontop of the module
frame.
Using a reciprocating saw with a 8" blade, cut the rail by placing the
blade flush against the Rail Cutting Guide and then carefully cut from
one side of the rail to the other. Take care to avoid damaging the roof
surface with the saw blade. NOTE: If needed, adjust the postion of the
shoe to prevent the blade from making contact with the roof.
Remove the Rail Cutting Guide from the cut rail. Sweep or vaccume
metalic dust and debris. Install QRail End Caps to the rail is desired.
Cutting Guide Instructions
Installation Tools Required: Reciprocating saw, 8 inch blade, Protective eyewear.
Note: Cutting Guides can accomodate a maxumum 40mm module frame size.
925-478-8269 | www.quickmountpv.com | [e-mail]
2700 Mitchell Dr. | Walnut Creek, CA 94598
1
2
3