Installation Guide
When attaching the rack, follow all the
directions of the rack manufacturer as
well as the module manufacturer.
All roo ng manufacturers’ written
instructions must also be followed
by anyone modifying a roof system.
Please consult the roof manufacturer's
specs and instructions prior to
touching the roof.
Set mount aside. Using drill with 7/32" bit, drill
pilot hole into roof and rafter, taking care to drill
square to the roof. Do not use mount as a drill
guide.
Clean o any sawdust, and ll hole with sealant
compatible with roo ng material.
Slide mount back into position. Prepare hanger bolt
with 1 hex nut (item 5) and 1 sealing washer (item
9), insert through QBlock into hole and drive hanger
bolt into rafter, tightening to a solid snug t.
Insert EPDM rubber washer (item 6) over hanger
bolt into QBlock.
2
3
5
4
6
8
7
1
Feb-2013, Rev 3
925-478-8269 www.quickmountpv.com info@quickmountpv.com
2700 Mitchell Dr., Bldg 2 Walnut Creek, CA 94598
Classic Shake Mounting Instructions
Installation Tools Required: tape measure, roo ng bar, chalk line, stud nder, caulking gun, sealant compatible with roo ng material,
drill with 7/32" bit, drill or impact gun with 1/2" deep socket, grinder or sander
Locate, choose, and mark centers of rafters to be
mounted. Select each row course of roo ng for
placement of Quick Mounts.
If necessary, remove shakes directly above
mount with the roofi ng bar to expose felt paper.
Flashing should reach at least 1" up and under
the felt paper for proper waterproofi ng.
Find the rafter center and level out any high spots
with a grinder or sander. Slide mount into desired
position on shakes, under felt paper, and mark
center for drilling.
*
Using the rack kit hardware, secure the rack of your
choice.
BI 7.2.3-11
WARNING: Quick Mount PV products are NOT designed for and should NOT be used to anchor fall protection equipment.
If the ashing doesn't reach under the felt paper
above, cut an additional piece of felt paper to layer
under the existing felt and over the ashing.
*