QMCC A Installation Guide

Using drill with 3/16" long bit, drill pilot hole into

roof and rafter, taking care to drill square to the

roof.

Clean o any sawdust, and ll hole with roof

manufacturer's approved sealant.

Lift shingle and slide conduit mount into place.

Prepare lag bolt with sealing washer and single hole

clamp (not included) as shown. Insert lag through

hole in block, and position clamp over conduit.

925-478-8269 www.quickmountpv.com info@quickmountpv.com

2700 Mitchell Dr., Bldg 2 Walnut Creek, CA 94598

Classic Conduit Mounting Instructions

Installation Tools Required: tape measure, roong bar, chalk line, stud nder, caulking gun, 1 tube of appropriate sealant, drill with

1/8" bit, drill or impact gun with7/16" deep socket.

Choose placement of conduit mounts along path

of conduit. Select location over center of rafter.

Lift composition roof tile with roong bar, just

above placement of conduit mount.

Slide conduit mount into desired position. Remove

any nails that conict with getting the mount ush

with front edge of shingle course. Mark cernter for

drilling.

Oct-2013, Rev 4BI 7.2.3-8

WARNING: Quick Mount PV products are NOT designed for and should NOT be used to anchor fall protection equipment.

Insert lag through hole in block, and position

clamp over conduit. Using drill with 7/16" socket,

drive lag until block is tight.

All roong manufacturers’ writ-

ten instructions must also be

followed by anyone modifying a

roof system. Please consult the

roof manufacturer's specs and

instructions prior to touching

the roof.