Installation Guide
BI 7.2.3-45 Dec-2019, Rev 2
Instructions: QMTRF - Tile Replacement Flashing
Installation Tools Required: tape measure, aviation type tin snips, chalk or crayon, roofing bar.
NOTE: Installation method is the same for all tile replacement flashing profiles.
1
WARNING: Quick Mount PV products are NOT designed and should NOT be used for anchoring fall protection equipment.
8
Remove a tile and install the tile hook of your choice to a
rafter. Properly ash the hook using prefered method.
Prop up adjacent tiles to the side and above using roong
bars.
Place the Tile Replacement Flashing matching the roof's
tile prole over the mount and measure or mark o the
position of the tile hook at the bottom edge of the ash-
ing.
1
2
Using a pair of tin snips, make two cuts to the bottom edge
of the ashing and bend the tab up, creating a space for
the tile hook to pass through.
When working with Flat and S shaped Tile Replacement Flashings it is permis-
sible to use a pair of tin snips, snip the bottom lip on the right side of the re-
placement ashing approximately 3/4" inch from the edge and bend the tab
under the adjacent tile to help keep the replacement ashing ush to the roof.
3
4
Place the cut Tile Replacement Flashing back over the
hook in place of the original tile. For replacement ashings
susceptible to movement, adhere ashing to adjacent
tile, using roong adhesive compatible with contacted
materials and environmental conditions, according to the
TRI Guidelines (see sections MC-21 & MC-24).
Optional Method for Securing Replacement Flashing