QRail Installation Guide

BI 7.2.3-46
Jul-2019, Rev 4.2
29
Image 6.4.1
Inner module installation step 1
Image 6.4.2
Inner module installation step 2
Image 6.4.3
Inner module installation step 3
Image 6.4.4
Tighten clamp bolt
NOTE!
The bonding mid clamps with bonding plates are supplied with
the bonding plates preassembled under the clamp head
If not already so positioned, slide the bonding plate and clamp
head to the bolt head. This will hold the bonding plate above
the module frames until you are ready to tighten the clamp into
place.
DANGER
Material damage due to incorrect
mounting
Incorrectly fastened modules can fall and
become damaged.
 Make sure the QClicks click in
securely
 Ensure the modules are flush against
both sides of the clamp.
 Observe and adhere to the
recommended torque specifications