QRail Tilt Supplemental Installation Guide

BI 7.2.3-46_1
May-2019 Rev 1
LOW EDGE
HEIGHT ABOVE ROOF
RAISED EDGE
HEIGHT ABOVE ROOF
SPACING
LOW EDGE RAIL
MOUNTED IN CENTER
OF VERTICAL ADJUSTMENT
RAISE EDGE RAIL
OFFSET FROM CENTER
OF VERTICAL ADJUSTMENT
MODULE
CANTILEVER
MODULE
QRAIL
QMQDM-3.75
(LOW EDGE MOUNT)
QMQDM-XXX
(RAISED EDGE MOUNT)
QMC-LF5
(5 DEGREE L-FOOT)
PANEL CLAMP
QRAIL TILT: QMQDM-3.75 LOW EDGE MOUNT WITH 5 DEGREE TILT
VARIABLES
PORTRAIT LANDSCAPE
60 CELL 72 CELL 60 & 72 CELL
LOW EDGE MOUNT QMQDM-3.75 QMQDM-3.75 QMQDM-3.75
RAISED EDGE MOUNT QMQDM-7.75 QMQDM-7.75 QMQDM-6.25
SPACING (IN.) 46 46 28
MODULE CANTILEVER (IN.) 9.41 15.91 5.94
RAISED EDGE RAIL OFFSET FROM CENTER OF
VERTICAL ADJUSTMENT (IN.)
+0.02 +0.02 -0.05
LOW EDGE HEIGHT ABOVE ROOF (IN.) 6.84 6.27 7.14
RAISED EDGE ABOVE ROOF (IN.) 12.51 13.07 10.63
1
DO NOT SCALE DRAWING
SHEET 1 OF 1
AAP
SCALE: 1:8 WEIGHT:
REV
A
SIZE
TITLE:
DATE:
DRAWN BY:
DIMENSIONS ARE IN INCHES
TOLERANCES:
FRACTIONAL
1/8
TWO PLACE DECIMAL
.19
THREE PLACE DECIMAL
.094
PROPRIETARY AND CONFIDENTIAL
THE INFORMATION CONTAINED IN THIS DRAWING IS THE SOLE PROPERTY OF QUICK MOUNT PV. ANY REPRODUCTION IN PART OR AS A WHOLE WITHOUT THE
WRITTEN PERMISSION OF QUICK MOUNT PV IS PROHIBITED.
COPYRIGHT © 2019 QUICK MOUNT PV
5
4
3
2
1
UNLESS OTHERWISE SPECIFIED:
83.03
QRAIL TILT: QMQDM-3.75 LOW EDGE
MOUNT WITH 5 DEGREE TILT
4/24/2019
Mounting Tables & Diagrams
Consult the Mounting Tables and diagrams below or download them o our website to determine proper
QBase Deck Mount heights and mount spacing. Mounting Tables and diagrams assume the following:
• Cantilever is assumed to be equivalent on both sides of the module.
• Tables and diagrams are based on the use of the Standard QRail with the low edge rail mounted in the
center of it’s vertical adjustment and the raised edge rail mounted with a slight oset from the center of
it vertical adjustment to create a mounting plane at the set tilt angle. Adjust raised edge oset, low edge
and raised edge heights o of the roof accordingly relative to site specific needs, rail selection, low edge
rail placement, and/or natural roof slope.
• 60-cell module in portrait orientation has an assumed module length of 65 inches; If module length dif-
fers, adjust cantilever, mount row spacing, low edge and raised edge accordingly.
• 72-cell module in portrait orientation has an assumed module length of 78 inches; If module length dif-
fers, adjust cantilever, mount row spacing, low edge and raised edge accordingly.
• 60-cell module and 72-cell module in LANDSCAPE orientation has an assumed module width of 40 inch-
es; If module width diers, adjust cantilever, mount row spacing, low edge and raised edge accordingly.