QRail System UL 2703 Edition 1 CDR

Report No. 101786065LAX-001
Quick Mount PV
Page 2 of 106
Issued: 25-Nov-2014
Revised: 27-Feb-2020
Product
Brand name
2.0 Product Description
Quick Mount PV
Description
The product covered by this report is a photovoltaic roof racking system. This system is
designed to be installed on low and steep-slope roofs. QRail Series consists of aluminum
support rails and top-down clamping hardware. It allows for both portrait and landscape
installation of the modules. This model is intended to be used with four top-down clamps to
secure a UL 1703 Listed framed PV module and the required electrical bond between the
anodized PV module frame and the QRail is accomplished by the use of QClick Technology PV
mid clamps with bonding plates and by the use of QClick Technology End Clamps are available
with and without Ground Clip to address bonding when necessary.
This system is in compliance with the bonding, grounding, and mechanical load portions of UL
2703. Fire testing was performed on this system and the ratings are shown below.
The grounding of the entire system is intended to be in accordance with the latest edition of the
National Electrical Code, including NEC 250: Grounding and Bonding, and NEC 690: Solar
Photovoltaic Systems. Any local electrical codes must be adhered in addition to the national
electrical codes. An entire array, regardless of size, is grounded via one ground lug (QMR-GLQ
or QMR-GLO) placed on the QRail of this roof system.
This product investigation was performed only with respect to specific properties, a limited
range of hazards, or suitability for use under limited or special conditions. The following
risks and other properties of this product have not been evaluated: electric shock, Ultraviolet
and light exposure.
Photovoltaic Racking System QRail - Installed Using Quick Mount PV's QRail Series Installation
Manual, "Jan-2020, Rev 8"
ED 16.3.15 (20-Apr-17) Mandatory