QuickRack Specs

Feb-2016, Rev 3BI 7.2.3-38
Slide the entire unit up under the bracket
clamp, and then slightly to the le so that the
cap screw holds everything together.
Tighten the cap screw with a half-inch socket
and torque wrench. Torque to 15 foot-pounds.
Neatly coil the wires and clip to module frame.
2
3
5
4
6
1
Enphase
®
Frame Mount Installation Instructions
Installation Tools Required: wire clips, 1/2" socket & torque wrench
In a standard landscape array, the Enphase
inverter bracket will be installed approximately
7" in from the edge of the module.
Place the bracket clamp over the edge of the
module frame.
With the cap screw threaded into the channel
on the bracket, slide the Enphase inverter on
top of the bracket with the cap screw in the
middle channel on the inverter.