Instructions / Assembly

QuickJack Portable Car Jack 35 P/N 5900959 — Rev. H — May 2018
Lowering the Frames from the Top Locking Position
Lowering the QuickJack’s Frames from the Top Locking Position is somewhat different from lowering
them from the First Locking Position.
⚠ WARNING When lowering QuickJack Frames, make sure the Lock Bar and the Release Cam
stay in their tracks. If they get knocked sideways, for example, they can get stuck
on the rail of the track, which could result in the QuickJack not lowering correctly.
To lower the QuickJack Frames from the Top Locking Position:
1. Press and hold Up until the Lock Bar is clear of the Lock Block.
2. Lift the Lock Bar
on both QuickJack Frames so that the Release Cam is on top of the Lock
Block on both Frames, as shown below.
You can use your hand or your foot to lift the Lock Bar.
3. Press Down
on the Pendant Control.
Make sure the Lock Bar and Release Cam clear the Lock Block on both QuickJack Frames on
their way down.
Release the Down button if either side does not clear the Lock Block.
4. Continue pressing Down until both QuickJack Frames are lowered to the ground.
Note: QuickJack recommends pressing Down for a few seconds
after the Frames are on the
ground; this ensures that as much Hydraulic Fluid as possible returns to the Fluid Reservoir.
5. Remove the QuickJack Frames from underneath the Vehicle; you may want to use the Quick
Frame Handles.
6. Move the Vehicle, if desired.
Make sure not to drive the Vehicle over the QuickJack Frames or the Hydraulic Hoses.