Instructions / Assembly
Table Of Contents
- QuickJack Manual
- Table of Contents
- Introduction
- Shipping
- Safety
- Components
- Accessories
- Specifications
- Frequently Asked Questions
- Setup
- Tools
- Selecting a Site
- Unpacking
- Air and Hydraulic Cylinders
- QuickJack Assembly Kit
- Installing the Hydraulic Elbow Fittings
- Preparing the Short Hydraulic Hoses
- Routing the Short Hydraulic Hoses
- Preparing the Long Hydraulic Hoses
- Pressurizing the Air Cylinders
- Preparing Your Power Unit
- Power Sources for VAC Power Units
- Power Sources for 12 VDC Power Units
- Installing Fittings on Your Power Unit
- Filling the Power Unit Hydraulic Fluid Reservoir
- Check the Breather Valve
- Bleed the Hydraulic Cylinders
- Test of Proper Setup
- Operation
- Maintenance
- Troubleshooting
- Wiring Diagrams
- Labels
- Parts Sheets
- Maintenance Log
- CE Documentation

QuickJack Portable Car Jack 33 P/N 5900959 — Rev. H — May 2018
⚠ WARNING Before doing anything else (like starting work on the Vehicle or leaving the area),
visually confirm
that
both
QuickJack Frames are on the same locking positions
and that all Lift Blocks are in contact with the factory-recommended Lifting Points
of the Vehicle.
You can work on your Vehicle once you have visually confirmed that both Frames are engaged on the
same locking position and all Lift Blocks are in contact with the Vehicle at the factory-recommended
Lifting Points.
⚠ WARNING Do not work under an elevated Vehicle unless properly rated Vehicle Jack Stands in
place at the factory-recommended Lifting Points.