Instructions / Assembly

QuickJack Portable Car Jack 32 P/N 5900959 — Rev. H — May 2018
Raising the Frames
When raising and lowering Vehicles, always leave them either engaged on a locking
position or fully lowered: your QuickJack has two locking positions, called First Locking Position
and Top Locking Position. All scissor lifts on the market, including the QuickJack, are engineered to
hold a full load only when they are engaged on a locking position.
⚠ WARNING Do not raise a Vehicle unless you are certain the Frames are properly positioned
under the Vehicle, that the Frames are as close to parallel as possible, that all
personnel are a sufficient distance away from the Vehicle, that the Lock Bars are on
the outside, and that there is open space on all sides and above the Vehicle.
To raise the QuickJack Frames:
1. Press and hold Up on the Pendant Control.
The QuickJack Frames start going up.
2. Just
before the Frames make contact with the Vehicle, release Up. The Frames stop moving.
Check the locations where the Lift Blocks will hit the factory-recommended Lifting Points on the
Vehicle. If necessary, adjust the Lift Blocks so that they are properly positioned (you may need to
lower the Vehicle some to adjust the Lift Blocks).
3. After confirming the Lift Blocks are properly positioned, press Up on the Pendant Control.
The QuickJack Frames start going up.
⚠ WARNING Do not stop raising the Frames until you have passed the First Locking Position.
4. Stop raising the QuickJack Frames just past the First Locking Position (even if you eventually want
them on the Top Locking Position).
5. Check the Lift Blocks to make sure they are contacting the factory-recommended Lifting Points.
If the Lift Blocks are in the right positions, continue with raising the QuickJack Frames.
If the Lift Blocks are
not in the right positions, press Down on the Pendant Control and carefully
return the Vehicle to the ground, then make the necessary adjustments.
6. Rock the Vehicle gently to test for stability.
If the Vehicle is stable, continue with raising the QuickJack Frames.
If the Vehicle is
not stable, press Down on the Pendant Control and carefully return the Vehicle
to the ground, then make the necessary adjustments.
7. Raise the Vehicle to just past the First Locking Position or the Top Locking Position, as desired.
8. When you have gone just past the desired locking position, press Down on the Pendant Control
to lower the Frames onto the locking position. The Frames will stop moving down when they lock.
9. Visually check to make sure both Frames are engaged on the same locking position.