Instructions / Assembly
Table Of Contents
- QuickJack Manual
- Table of Contents
- Introduction
- Shipping
- Safety
- Components
- Accessories
- Specifications
- Frequently Asked Questions
- Setup
- Tools
- Selecting a Site
- Unpacking
- Air and Hydraulic Cylinders
- QuickJack Assembly Kit
- Installing the Hydraulic Elbow Fittings
- Preparing the Short Hydraulic Hoses
- Routing the Short Hydraulic Hoses
- Preparing the Long Hydraulic Hoses
- Pressurizing the Air Cylinders
- Preparing Your Power Unit
- Power Sources for VAC Power Units
- Power Sources for 12 VDC Power Units
- Installing Fittings on Your Power Unit
- Filling the Power Unit Hydraulic Fluid Reservoir
- Check the Breather Valve
- Bleed the Hydraulic Cylinders
- Test of Proper Setup
- Operation
- Maintenance
- Troubleshooting
- Wiring Diagrams
- Labels
- Parts Sheets
- Maintenance Log
- CE Documentation
QuickJack Portable Car Jack 23 P/N 5900959 — Rev. H — May 2018
Installing Fittings on Your Power Unit
Before you can connect your Power Unit to the Long Hydraulic Hose, you first need to install Quick-
Connect Fittings to the hydraulic ports on the front of the Power Unit.
You only have to install these fittings once. To move your QuickJack later, just disconnect the Power
Unit from the Long Hydraulic Hoses using the Quick-Connect Fittings.
To connect Power Unit Quick-Connect Fittings to Power Unit hydraulic ports:
1. On the Power Unit, remove the plastic shipping plugs from the two hydraulic ports on the front.
2. Get a Power Unit Quick-Connect Fitting from the QuickJack Assembly Kit, insert the O-ring side
into one of the two hydraulic ports on the front of the Power Unit, then tighten to 11-12 lb-ft /
14-16 N-m.
Do not use Thread Seal Tape on the O-ring threads.
3. Repeat for the second Quick-Connect Fitting on the Power Unit.