Instructions / Assembly
Table Of Contents
- QuickJack Manual
- Table of Contents
- Introduction
- Shipping
- Safety
- Components
- Accessories
- Specifications
- Frequently Asked Questions
- Setup
- Tools
- Selecting a Site
- Unpacking
- Air and Hydraulic Cylinders
- QuickJack Assembly Kit
- Installing the Hydraulic Elbow Fittings
- Preparing the Short Hydraulic Hoses
- Routing the Short Hydraulic Hoses
- Preparing the Long Hydraulic Hoses
- Pressurizing the Air Cylinders
- Preparing Your Power Unit
- Power Sources for VAC Power Units
- Power Sources for 12 VDC Power Units
- Installing Fittings on Your Power Unit
- Filling the Power Unit Hydraulic Fluid Reservoir
- Check the Breather Valve
- Bleed the Hydraulic Cylinders
- Test of Proper Setup
- Operation
- Maintenance
- Troubleshooting
- Wiring Diagrams
- Labels
- Parts Sheets
- Maintenance Log
- CE Documentation
QuickJack Portable Car Jack 17 P/N 5900959 — Rev. H — May 2018
To set up and connect the Short Hydraulic Hoses:
1. Locate both Short Hydraulic Hoses and remove their protective caps.
2. Wrap the male threaded fittings on each Short Hydraulic Hose with Thread Seal Tape.
Only one end of a Short Hydraulic Hose has a male threaded fitting; the other end has a female
fitting that attaches to the Hydraulic Elbow Fitting on the Hydraulic Cylinder.
Remember to wrap the threads three times in the same direction you will be turning the threaded
fittings when you connect them.
3. Attach one male Quick-Connect Fitting from the QuickJack Assembly Kit to the male threaded
fitting end of the Short Hydraulic Hose; tighten to 23-25 lb-ft / 31-34 N-m.
Repeat for the other Short Hydraulic Hose.
4. Connect the female connector on the Short Hydraulic Hose to the male connector on the Hydraulic
Elbow Fitting (which should already be installed on the Hydraulic Cylinder).
5. Route both Short Hydraulic Hoses
under
the Frame ends; make sure they are clear of pinch
points.