User guide

30-7025 – 2-PORT PLUS+ REGULATOR
INSTALLATION AND ADJUSTING INSTRUCTIONS:
Your Two Port Regulator has been pre-set to approximately 6 PSI. This is a good starting point. Pressure should always
be set with the engine idling. Failure to do this can result in damage to the regulator's internals due to excessive over-
adjustment. Turning the adjustment stud clockwise will increase pressure, counter clockwise will decrease pressure. The
regulator pressure is adjustable between 5 and 8 PSI.
QFT™ recommends mounting the regulator as close as possible to the carburetor.
The hole in the top of the cap is a vent and should be left open and kept clear to assure proper regulator function.
Remember, after installation, check for any leaks. Your safety depends on it.
Figure 1
SERVICE PARTS AND ACCESSORIES
ITEM
PART NUMBER
#8 AN O-ring to #6 AN, red anodized (Outlet Port)
19-106-2
#8 AN O-ring to #6 AN, black anodized (Outlet Port)
19-106-2BLK
#8 AN O-ring to #8 AN, red anodized (Outlet Port)
19-108-2
#8 AN O-ring to #8 AN, black anodized (Outlet Port)
19-108-2BLK
#10 AN O-ring to #8 AN male, black anodized (Inlet Port)
19-1008
#10 AN O-ring to #10 AN male, black anodized (Inlet Port)
19-1010
For warranty information, please see our website at www.quickfueltechnology.com.
For further questions, please contact our technical department at 1-270-793-0900.
99-30-7025
Revision Date: 12-17-13