Full Product Manual

5
Water-Gate Manual | www.quickdams.com
3. Making a round curve to REPEL the water:
A - Completely unfold the
Water-Gate.
C - In the event there are pockets
from curving the barrier, try to
eliminate them by using small
weights to keep the fabric on the
ground & prevent wind from
lifting up.
B - Give the Water-Gate the
desired curve.
4. Making a round curve to CONTAIN the water:
A - Completely unfold the
Water-Gate.
B - Curve the Water-Gate
as needed, making sure the back
of the Water-Gate is not stretched.
C - Sandbags can be used to
close off the spaces or folds
formed by the Water-Gate
ballast weights.
2. Square corner to CONTAIN the water:
Please note that containing water with the Water-Gate system can be difcult & often results in excessive
seepage.
A - Completely unfold
the Water-Gate.
C - From the red weighted
side, pull the material up
in the middle, spread it
out & place on top. Lift
the upper back walls on
both sides to be sure that
water can enter.
B - Place weights at the
back of the Water-Gate
as a pivot point and curve
the barrier to the angle
required to contain
the water.
D - Remove the pivot
weight from the back
edge & place them
on the front edge to
prevent inltration
under the folds