How to Guide

GENERAL MAINTENANCE AND INSTALLATION
Keep the Allen Screws and Allen Wrench in a safe place as they will be needed to secure the
stanchion to the Base in the event of a flood.
Removing the clamp
1. There are (4) 1/2 in. - grub screws with every stanchion.
These must be coated with a waterproof grease or
anti-seize compound and screwed into the holes on each plate.
This will protect the threads in the plate and allow traffic to move
across the anchor plate without damaging the threads
(See illustration Q).
2. These plugs should be flush with the top of the base
and no deeper. They should also be re-greased
periodically and after every use to ensure they will come
out when needed.
To prevent any leaking between the top of the Base and the bottom of the Stanchion there is a
machined 3/16” groove which should be filled with silicone caulk to add additional sealing
(See illustration R).
Always keep the top of the Base and the Bottom of the Stanchion clean and free of nicks and dents
as these are critical sealing surfaces.
Maintaining the Base
Before installing the stanchion
Maintaining the sealing surfaces
13
SEALING
GROOVE
ILL R
ILL Q