User manual

QT ZM66
User Manual
User Manual
Q-Tech Commercial Series
QT ZM66
7
Rear Panel Layout
AC Inlet16.
Connect to the supplied power cord 
IN Common relay music zone17.
Output Power Control Relay18.
Mixed output, music and paging19.
Music Signal Output20.
Paging Signal Output21.
Contact for playback of messages 22.
1 & 2
The third message is activated by Microphone 
base directly
Message Selection Switch: OFF,1,2,323.
This is used to select the message to record 
Message 1 selection mode switch24.
1 Time:

The recorded message plays only once.
Continuous: 
The recorded message plays continuously till 
the message contact is remotely closed
Alarm Selector switch25.
The mixer will operate without the QT ZM66M 
paging console and announcements may be
made via a remote microphone in emergency
situations
Alarm: 
The announcement is simultaneously 
distributed in all the 6 zones
Normal: 
The announcement is distributed only in the 
zone selected with front panel buttons
Message record level26.
Message playback level27.
Phantom power select switch28.
Chime volume control29.
Priority control port for BGM and 30.
internal chime
Input RJ45 console31.
Max 6 microphone consoles in parallel 
QT ZM66M input level control32.
QT ZM66 gain control33.
Microphone gain control34.
Microphone Input XLR Balanced35.
Audio Source Interface36.
OUT zone (1~6)37.
Output relay zone contacts38.
30
3132333435363738
16 17 18 19 20 21 22
23 24 25 26 2827 29