User manual

Compression: An electronic device that
reduces the dynamic range. In other words,
makes the loud parts of the music less loud
and the quiet parts appear louder. When used
correctly it can make live music sound more
even and balanced.
Limiter: An electronic device that will prevent
the signal from exceeding a set level of
output. Normally used as a system protec-
tion to prevent it from being over driven by
excessive input.
Phase (in or out of phase): This really means
speaker polarity. The input terminals of a
normal loudspeaker have a + positive red
terminal and a - negative black terminal.
In the case where there are two speakers
operating as a pair or together as an array,
will need to all be wired the same way. If a
speaker connecter, speaker lead or speaker
box is wired in reverse to a box near it, loss
of performance will result. This may be in the
form of lost low frequency response. In this
case you will see the bass speaker working
hard but as you move away from the box, the
bass frequencies will seem to “disappear”.
Check that your speaker leads do not have
one lead wired in reverse at one end and
that the speaker boxes are all wired correctly
internally. This can happen when a speaker
box has been repaired and then not assem-
bled with the wiring connected correctly.
Input
Signal
Electronic
xover
Low Freq.
Amp
Low Freq.
Drive
Hi Freq.
Drive
Hi Freq.
Amp
Clipping
Clipping
GLOSSARY
4
Glossary
Basic professional audio practice
and hints for best results
Pre amplier: That part of the signal chain
where a signal from a microphone, turnta-
ble, CD player or other signal source is rst
amplied. This will normally be at the input of
a mixer and is necessary to boost the signal
enough to be then mixed and amplied by a
power amplier.
Power amplier: Boosts the signal enough
so it can be reproduced by a loudspeaker.
Electronic cross over: Splits up the full
range audio signal to separate high and
low frequencies. This is done to send low
frequencies to the bass speaker and high
frequencies to the tweeter or high frequency
horn driver.
Self powered: Refers to a speaker or a mixer
that contains a power amplier.
Clipping: Distortion that is caused by having
too much signal at an input causing the
amplier to overload. It is called clipping
because it will cause a smooth wave to be
cut off at the peak of the wave. In other
words, “clipped”
Gain structure: The relationship of input
levels to output levels in a signal chain. An
example of incorrect gain structure is when
a mixer is turned up to the point of audible
distortion (red lights ashing serious over-
load), and the power ampliers are turned
down and running at only 30% power.
Compressor
Threshold
Limiter
Threshold
1:1
3:1
Output Level
10
10
Output Level
10
10
1:1
0:1
QSA 300
Active Speakers
User Manual
QSA 300
User Manual