User manual
QM 1000P
User Manual
User Manual Q Motion Series
QM 1000P
6
DO NOT OPEN
RISK OF E LECTR IC S HOCK
CAUTION
Rear Panel Layout
. Satellite high pass crossover
The satellite speakers can be powered with full
range signal or a cross-over to sub frequency of
80Hz or 120Hz can be selected. For 8” speakers,
120Hz is suggested. When using 10”-12” speakers,
80Hz is be preferable and high powered 12” or 15”
speakers can be set to full range.
. Inputs
Connect signal leads from your mixer (master
left/right, line out, to the balanced inputs using
XLR mic leads. XLR connectors to be wired as
follows: 1 ground, 2 +, 3 -.
2
1
3
3
. Outputs
Speakon output connectors on rear wired L&R
pin 1+ pin1-. Neutric NL4 or NL2 connectors
are recommended. The total impedance per
output should not be below 4Ω (Ohms)
(3.7Ω DC resistance). 2 x 8Ω satellite
speakers and 1 x 8Ω bass speakers can be
connected per amplier output.