User manual

HPi110 & HPi210
Quick Rig (QR) Systems
User Manual
HPi110 & HPi210 Quick Rig (QR) Systems
17
Mounting the Speaker &
Rigging System
The hanging plate for 3 speaker allows for 3
sets of angles. Installation Examples
For application where wider dispersion is
required, the 3 speakers can be angled at 15
o or 20o delivering an extremely simple to
install wide dispersion array solution.
Please ensure that regardless of the angle,
each speaker is secured with 2 x M10 screws.
Mounting the hanging plate:
1. Remove the 2 M10 screws at the top of
each speaker.
2. Place the hanging plate on top of the 3
speakers and align to the desired angles.
3. Bolt in the 6 M10 x35 counter sunk
screws included in the kit. (Add Loctite
to give additional fastener security)
4. Remove 2 of the 4 x M6 top hat screws
(front and at the rear), at the base of
each speaker.
5. Attach the complete bottom plate with
the M6 screws included with the kit. (The
screws that were in the speaker can be
used if used in conjunction with a thread
locker such as Loctite)
The bottom plate suits the use of 2 speaker
in all configurations, as well as the assembly
of 3 speaker in an horizontal array (all angles
too).
The two plates should be located on each
other so the metal thickness below all
speakers is in level alignment.
Top view of 3 x HPi110’s installed with the QR4 kit.
Bottom view of 3 x HPi110’s installed with the QR4 kit
Bottom plate – part of horizontal kits QR3 and QR4
A couple of bottom plates as used in a
triple horizontal array QR4
Installation Examples