User manual

HPi110 & HPi210

Quick Rig (QR) Systems

User Manual

HPi110 & HPi210 Quick Rig (QR) Systems

Installation of the Spine on the HPi110

NOTE: The 2 x M10 bolts supplied with both the i-Spine and t-Spine should replace the

previously installed screws in the speaker. The M10 bolts are designed with a longer thread

which provides increased strength and security to the system.

Primary Applications Include:

• Wall Mount applications where tilt is

not needed

• Vertically Arraying 2 Speakers

The touring Spine (t-Spine) is

recommended for a precise and easy

hanging setup of the speaker when

used when flying a single speaker.

The holes, on each side, allow for a 5o

stepped tilt of the cabinet [from -15o

to +45o]

Only one rated shackle is necessary

to use the Spine in most applications.

(A quick-pin is also included with the

t-Spine)

The t-Spine can also be used as part of

a more complex rigging system.

Ordering reference:

ACHPiATS

Remove the 2 top

screws that are

installed in the speaker

then insert the lip of

the Spine to grab the

casing handle.

Swing it flat on the

top of the speaker.

Bolt in and secure

(using Loctite or similar

fastener securing

compound) the Spine

onto the speaker with

the 2 x M10 bolts

included.

2 3