Installation manual

Installation Guide
3
Warnings and Cautions
• Handle the camera carefully
Do not abuse the camera. Avoid striking, shaking, etc. The camera could
be damaged by improper handing or storage.
• Installing electricity wiring carefully
Ask qualified personnel of electrical wiring for the installation. Please note
that input electricity to the unit is at tolerance of DC12V/AC24V ± 10%.
The camera is capable of surge protection; ensure AC power model unit
grounded appropriately against damage of heavy current or electric
shock.
Refer to the camera’s installation guide for more information.
AC model data cable AC power input: 3-pin terminal block
• Do not disassemble the camera
To prevent electric shock, do not remove screws or covers. There are no
user serviceable parts inside. Ask a qualified service person for servicing.
• Do not block cooling holes on the bracket
This camera has a cooling fan inside. Blocking the cooling holes leads to
build up of heat the camera and may cause malfunction.
• Do not operate the camera beyond the specified temperature,
humidity or power source ratings
Use the indoor dome camera under conditions where temperature is
between 0°C ~ 40°C (32°F ~ 104°F) and the outdoor camera under
conditions where temperature is between -30°C~45°C (-22°F~104°F), and
humidity is below 90%.
• Do not expose the indoor dome camera to rain or moisture, or try to
operated it in wet areas
The indoor dome camera is designed for indoor use or locations where it
is protected from rain and moisture. Turn the power off immediately if the
camera is wet and ask a qualified service person for servicing. Moisture
can damage the camera and also create the danger of electric shock.