Installation manual

Installation Guide
17
• RS-485 cable carries commands from a control device to the dome
cameras. A CAT 5, 24 gauge cable is recommended.
• The power cable provides either AC 24V or DC 12V power supply to the
dome.
NOTE: Ensure power supply corresponds with the dome’s power
requirement, or product impairment will occur. If any mistake happens,
please contact with a qualified maintenance engineer.
3.4.2 22-Pin Data Cable
DC 12V Data Cable
Power Input
DC12 Female Jack
Video
Output
BNC Connector
RS485
Connector
2 wires
4 wires
AC 24V Data Cable
Power
Input
3-Pin Terminal Block
Video
Output
BNC connector
RS485
Connector
2 wires
4 wires
NOTE: Be careful not to pull the cables improperly during installation.
Additionally, it is suggested to fasten the cables after cable connection
is completed. Furthermore, when wiring the power cable, make sure the G/Y
wire (Ground) inserted into the mid-pin of the terminal block.