Installation manual

Installation Guide

RS-485 Setting

Half-duplex

Full-duplex

3.3.3 Dome ID Setting

Please change the dome ID if there is more than one dome on the same

installation site. Before installing the dome camera, use the switch to change

your speed dome ID by turning the arrow to the desired number respectively.

For instance, if the dome ID is 123, the ID switch should be set as shown

below.

NOTE: No two domes should be given the same ID, or communication

conflict may occur. In addition, the number “0” should locate upwards

as shown in the diagram for correct switch definition.

Centesimal Digit Decimal Digit Single Digit it

NOTE: The number “0” should locate upwards as shown in the

diagram above for correct switch definition.

3.3.4 Dome Control Protocol Setting

Define the protocol you are going to use basing on the devices of your

surveillance system. Generally, use one protocol even the devices are

provided from different manufacturers. Use the switch to set your dome

control protocol and the baud rate. Refer to the table below and turn the

arrow to choose a protocol for your speed dome.