Users Manual

MicroSD Card Commands
mount = sdcard mount
In FAT32 format if the microSD card (or SD card) was not properly
unmounted, this command will result in the following syslog message:
“Volume was not properly unmounted. Some data may be corrupt. Please
run fsck. ” Since EdgeMarc no longer supports dos fsck tool, this must be fixed
either on an EdgeMarc with pre-15.3.0 VOS or on an appropriate Windows
system.
unmount = sdcard umount
format* = sdcard format
Please note that Quick Format is not available in EdgeMarc versions 15.3.0
and above. A microSD card of 32 GB can take up to 35 minutes to be
formatted.
name/rename SD card* = sdcard volume <volume name>
status* = sdcard check
*Supports only Ext3 file system
EdgeMarc files
You can copy the following types of files to and from the microSD card using the
CLI: conf1, conf2,
syslog, pcap, mand logs, sys_report output.
TFTP server
The TFTP file server is used for endpoint configuration file storage.
FTP server
The FTP file server is used for endpoint configuration file storage.
Remote
access
SSH into the EdgeMarc 6000 via SCP for remote access to the microSD card and
files within the microSD card.
System alert
for microSD
card
insert/removal
A system alert is issued when a microSD card is inserted or removed. The alert
contains the timestamp of the event.
Console Cable Pinouts
The pinout of the Console cable RJ45-to-DB9 is given below.
Figure 4: Console Cable
Table 7: Console cable pinout table
PIN
RJ45 Signal
RJ45 to DB9
DB9 Signal
PIN
1
NC
_
_
_
2
NC
_
_
_
Confidential and Proprietary. Copyright © 2019 Ribbon Communications Operating Company, Inc. (''Ribbon''). All rights reserved. Page 13