Manualshelf

Installation Manual

ManualsBrandsQuectel ManualsElectronicsTelematic device for asset management with LTE/GPS module and Wi-Fi&BT module
12345678910
1312
INSTALLATION
INSTALLATION
The following section describes the installation steps for AM35 devices. Vehicle cables and screws
are not included
1. Disconnect the vehicle battery main switch, and maintain it disconnected for the duration of the device
installation process.
2. Install the device using bolts on dedicated mounting holes.
3. Guarantee a full contact of bottom cover toward the vehicle with a at surface. AM35XB can be placed with no
orientation recommendation. AM35XT must be orientated with the top towards the sky to improve the GNSS
internal antenna performance.
4. Guarantee to mount the device in a protected place (e.g. inside the vehicle cabin).
AM35 DEVICES INSTALLATION
WARNING - NEVER cover the vent hole in the bottom of the AM35 device
with tape or Velcro. Covering the vent hole may cause device failure, as the
vent hole releases humidity caused by temperature changes.
Mounting
Holes
Mounting
Holes
Vent Hole
5. Connect the vehicle cables to the device through the connectors.
Ensure that the battery line is protected by a 5A automotive fuse.