Installation Manual

2322
1. Changes or modications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
2. This device model AM35XT/AM35XB/AM35LT contains IC:28545-AM35 and:
IC: 10224A-201611EC21A (Modem version EC21A)
3. Responsible party’s contact located in the Canada:
Name: Stephen Rosenegger
Address: Topcon Positioning Systems Inc, 855-2 Street SW, Suite 3500 Calgary AB T2P 4J8 Canada
Telephone number: [phone]
4. This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic
Development Canada’s licence exempt RSS(s). Operation is subject to the following two conditions: (1) This device
may not cause interference. (2) This device must accept any interference, including interference that may cause
undesired operation of the device.
L’emetteur/recepteur exempt de licence contenu dans le present appareil est conforme aux CNR d’Innovation,
Sciences et Developpement economique Canada applicables aux appareils radio exempts de licence. L’exploitation
est autorisee aux deux conditions suivantes : (1) L’appareil ne doit pas produire de brouillage; (2) L’appareil
doit accepter tout brouillage radioelectrique subi, meme si le brouillage est susceptible d’en compromettre le
fonctionnement.
5. ICES-003 Class B Notice -Avis NMB-003 Class B :
This Class B digital device complies with Canadian ICES-003
Cet appareil numerique classe B est conforme à la norme Canadien NMB-003.
CAN ICES-3(B) /NMB-3(B)
ISED
This device complies with Directive 2014/53/EU issued by the Commission of the European Community.
Approval number: E8*10R06/01*13462*00
Approval mark:
RED
ECE-R10
10R-06 13462
8
CERTIFICATIONS
1. Changes or modications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
2. This device model AM35XT/AM35XB/AM35LT contains FCC ID: 2A6VC-AM35 and:
FCC ID: XMR201606EC21A (Modem version EC21A)
3.This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
4. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC
CERTIFICATIONS
This device complies with Radio Equipment Regulations 2017 (S.I. 2017/1206) of the UK Parliament relating to the
making available on the market of radio equipment.
UCKA