AM35 SERIES Installation Manual
TABLE OF CONTENTS PREFACE.............................................................................................................. 2 INTRODUCTION................................................................................................... 4 SPECIFICATIONS.................................................................................................. 8 INSTALLATION.................................................................................................... 12 BATTERY PACK WARNINGS.......
PREFACE PREFACE Thank you for purchasing this Tierra product. The materials available in this Manual (the “Manual”) have been prepared by Tierra S.p.A. (“Tierra”) for customers of Tierra products, and are designed to assist customers with the use of the receiver and its use is subject to these terms and conditions (the “Terms and Conditions”). NOTICE - Please read these Terms and Conditions carefully.
INTRODUCTION INTRODUCTION AM35 Series is Tierra’s third generation of devices and the result of our long-standing expertise in providing advanced telematics and bringing meaningful improvements in our HW to keep on meeting our customers’ necessities. Three versions of AM35 have been designed to suit the market requirements.
INTRODUCTION AM35 LED DISPLAY PANEL INTRODUCTION AM35 MAIN ENVELOPE DIMENSIONS Power LED (Red): • OFF - No power supply. • Double blink - powered and working. • Rapid blinking - key off. CAN-BUS LED (green): • Off: CAN-BUS signal not available. • Solid On: can messages received from at least one line. MODEM LED (green): • Off: Modem initialization phase. No network coverage or device in standby/wake mode. • Slow Blink: GSM networks detected.
SPECIFICATIONS SPECIFICATIONS AM35XT Wakeup sources SIM WiFi/BLE Memory RAM Flash NAND LED Ports & Connectors Serial Port[1] CAN Bus Connector Cellular technologies multi-mode modem RF Output power Bluetooth E-GSM 900 Antennas (Internal) GNSS Receiver Frequency Motion Sensor Input/Output Input Device Output Devices Power Supply Input Battery Batteries Remote Capabilities Configuration Firmware Update[2] Environmental[3] Water/Dust Resistance Operating Temperature Range[4] Humidity Physical Dimensions Weig
SPECIFICATIONS SPECIFICATIONS AM35LT Wakeup sources SIM WiFi/BLE Memory RAM Flash NAND LED Ports & Connectors Serial Port[1] CAN Bus Connector HW Latch Cellular technologies multi-mode modem RF Output power Bluetooth E-GSM 900 Antennas (Internal) GNSS Receiver Frequency Motion Sensor Input/Output Input Device Output Devices Power Supply Input Battery Batteries Remote Capabilities Configuration Firmware Update[2] Environmental[3] Water/Dust Resistance Operating Temperature Range[4] Humidity Physical Dimen
INSTALLATION INSTALLATION The following section describes the installation steps for AM35 devices. Vehicle cables and screws are not included WARNING - NEVER cover the vent hole in the bottom of the AM35 device with tape or Velcro. Covering the vent hole may cause device failure, as the vent hole releases humidity caused by temperature changes. AM35 DEVICES INSTALLATION 1. Disconnect the vehicle battery main switch, and maintain it disconnected for the duration of the device installation process. 2.
INSTALLATION INSTALLATION 6. Connect the antenna cables (AM35XB only). NOTICE - If the device is not properly installed, any motion detected by the internal accelerometer will have a negative impact. False readings will occur unless the device is firmly in place. WARNING - DO NOT ALLOW the CM1X or the components of the telematic system to BLOCK or LIMIT your view outside the cab. Use goggles when drilling, cutting, or grinding on the machine.
INSTALLATION INSTALLATION CONNECTOR PINOUT Pin # Signal Color Pin # Signal Color 1 +30 Red 10 GND Black 2 +15 Orange 11 Chassis Grey 3 In0 Brown 12 In1 Turquise 4 In2 Pink 13 In3 Blue 5 CAN1_L Green 14 CAN1_H Yellow 6 CAN2_L Red/Green 15 CAN2_H Red/Yellow 7 Out0_LS Red/Black 16 Out1_HS White/Red 8 Out2_LS White/Black 17 Out3_HS White/Green 9 RS232_Out Violet 18 RS232_in White NOTICE - The wiring schematics are noted as recommendations by Tierra,
BATTERY PACK WARNINGS DANGER - Opening the device by Unauthorized Personal VOIDS the Warranty! Never attempt to open the casing of the detachable batteries! NiMH batteries can be dangerous if mishandled! TROUBLESHOOTING Connectivity is the most common customer technical issue. Troubleshooting involves a series of tests to isolate the issue to the main points of failure (outlined below) from which the root cause can be identified, followed by the resolution.
TECHNICAL SUPPORT LINK TO USER GUIDE If the troubleshooting hints and tips in this Installation Manual fail to remedy the problem, please contact Tierra Support: support-tierra@tierratelematics.com Once the device is installed and running, you can access the User Guide at the following link: http://www.tierratelematics.com/download/AM35InstallationManual.pdf When emailing, please provide the following information for better, faster service: 1. The device version. 2.
CERTIFICATIONS CERTIFICATIONS FCC ISED 1. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. 2. This device model AM35XT/AM35XB/AM35LT contains IC:28545-AM35 and: IC: 10224A-201611EC21A (Modem version EC21A) 1. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. 2.
Part Number TRR-MAN-01-02 Rev A © Copyright Tierra S.p.A. July, 2022 All contents in this manual are copyrighted by Tierra S.p.A. All rights reserved. The information contained herein may not be used, accessed, copied, stored, displayed, sold, modified, published, or distributed, or otherwise reproduced without express written consent from Tierra S.p.A.
TIERRA S.p.A. Corso Ferrucci, 112 - 10138 Torino - Italy www.tierratelematics.