EVB User Guide V1.0
Table Of Contents
- Safety Information
- About the Document
- Contents
- Table Index
- Figure Index
- 1 Introduction
- 2 General Overview
- 3 Interface Application
- 3.1. Power Supply (J0202/J0601)
- 3.2. Switches, Button and Status Indicators
- 3.3. M.2 Interface (J0101)
- 3.4. USB Type-C Interface (J0601)
- 3.5. USB-TO-UART Interface (J0901/J0902)
- 3.6. (U)SIM Interfaces (J0701/J0702)
- 3.7. Audio Interfaces (J0801/J0802/J0803)
- 3.8 PCIe Interface to WLAN/Ethernet Module (J0501/J0502)
- 3.9. Antenna Interfaces
- 3.10. Test Points
- 4 Operation Procedures
- 5 Appendix References
5G Module Series
5G-M2_EVB_User_Guide 31 / 34
4.4. Reset the Module
Press the RESET button (S0102) to reset the module. But the reset option is only used in case of
emergency. For example, the software does not respond for more than 5 s due to some serious problems.
4.5. Turn Off the Module
There are two methods to turn off the module.
⚫ Hardware method: switch S0201 to PWR_OFF side to turn off the module.
⚫ Software method: send AT+QPOWD command to turn off the module, which is preferred and safer
since the module will log off from the network and save data before shutdown.
Pressing the RESET button (i.e., triggering the RESET# signal) will lead to loss of all data in the modem
and removal of system drivers. It will also disconnect the modem from the network.
Please refer to document [3] for more details about AT+QPOWD command.
NOTE
NOTE