User Guide
Table Of Contents
- 1. Scope
- 2. LMU-3040 Hardware Specifications
- 3. LMU-3040™ Connectors
- 4. Getting Started
- 4.2 SSH Credentials
- 4.3 Interactive “AT Console”
- 4.4 Command Line Interface (CLI)
- 4.5 Log File
- 4.6 Backup Logs
- 4.7 File Components
- 4.8 Software & Script Updates
- 5. PEG2
- 5.2 PEG2 File
- 5.3 PEG2 TAG Definitions
- 5.4 Multiple Modifiers
- 5.5 PEG1 -> PEG2 Conversion
- 5.6 PEG2 Native Editor
- 6. LMU32 vs EdgeCore Platform Differences
- 6.1 I/O Mapping & Wake-Up Sources
- 6.2 LMU Firmware Updates (Delta Files)
- 6.3 Vehicle Bus PID Polling Rate
- 6.4 PEG2 “Lines”
- 6.5 Event Index Field
- 6.6 Remote Debug PEG Action
- 6.7 Modem/GPS Reset
- 6.8 SIM Form Factor
- 6.9 Boot Reason
- 6.10 Peg Resources
- 6.11 GPS
- 6.12 Motion Logs (4hz vs 5hz GPS Sample Rate)
- 6.13 Time Sync Precedence
- 6.14 Version String in ID Reports
- 6.15 Firmware Revision Convention
- 6.16 Status LEDs
- 6.17 Dual APN Mode
- 6.18 Version Reports (App Message 111)
- 7. Installation Verification
- 8. Regulatory Information
COMPANY CONFIDENTIAL: CalAmp reserves all rights to these documents and any information contained therein. Page
Reproduction use or disclosure to third parties without express permission is strictly prohibited. ©2021 CalAmp 24 of 40
LMU-3x40 Training Guide
Revision & Date
1.6 – 03/24/2021
6. LMU32 vs EdgeCore Platform Differences
6.1 I/O Mapping & Wake-Up Sources
Inputs 0-4 and Input 14 are mapped the same on the LMU-3040 as they are on the LMU-3030.
However, on the LMU-3x40 platform, these same enumerated inputs are NOT used as wake-up
sources.
Monitoring the status of these inputs within a PEG Script is the same as on the LMU-3040,
however, to set these inputs
as a wake-up source requires setting a different input in param
1029. This also means that the settings for Input 0-4 or Input 14 on a LMU-3040 will have no
effect on the device.
For example, in order to wake-up on Power State on the LMU-3x40 , you will need to set Input 18
via Param 1029 (i.e. Param 1029, Index 2, Bit 2) in the PEG Config. Below, in bold, are the
possible wake-up sources for the LMU-3x40 that can be set or cleared in Param 1029.
I/O
LMU-3030
LMU-3040
LMU-3240
Input-0
Ignition
Ignition
Ignition
Input-1
Motion Wake
Motion
Motion
Input-2
Pwr State Wake
Pwr State
Pwr State
Input-3
Vbatt Low Wake
Vbatt Low
Vbatt Low
Input-4
Batt Virt Ign
Batt Virt Ign
Batt Virt Ign
Input-5
Input-6
Input-5
Input-6
Input-7