User Guide
Table Of Contents
- 1. Scope
- 2. LMU-3040 Hardware Specifications
- 3. LMU-3040™ Connectors
- 4. Getting Started
- 4.2 SSH Credentials
- 4.3 Interactive “AT Console”
- 4.4 Command Line Interface (CLI)
- 4.5 Log File
- 4.6 Backup Logs
- 4.7 File Components
- 4.8 Software & Script Updates
- 5. PEG2
- 5.2 PEG2 File
- 5.3 PEG2 TAG Definitions
- 5.4 Multiple Modifiers
- 5.5 PEG1 -> PEG2 Conversion
- 5.6 PEG2 Native Editor
- 6. LMU32 vs EdgeCore Platform Differences
- 6.1 I/O Mapping & Wake-Up Sources
- 6.2 LMU Firmware Updates (Delta Files)
- 6.3 Vehicle Bus PID Polling Rate
- 6.4 PEG2 “Lines”
- 6.5 Event Index Field
- 6.6 Remote Debug PEG Action
- 6.7 Modem/GPS Reset
- 6.8 SIM Form Factor
- 6.9 Boot Reason
- 6.10 Peg Resources
- 6.11 GPS
- 6.12 Motion Logs (4hz vs 5hz GPS Sample Rate)
- 6.13 Time Sync Precedence
- 6.14 Version String in ID Reports
- 6.15 Firmware Revision Convention
- 6.16 Status LEDs
- 6.17 Dual APN Mode
- 6.18 Version Reports (App Message 111)
- 7. Installation Verification
- 8. Regulatory Information
COMPANY CONFIDENTIAL: CalAmp reserves all rights to these documents and any information contained therein. Page
Reproduction use or disclosure to third parties without express permission is strictly prohibited. ©2021 CalAmp 11 of 40
LMU-3x40 Training Guide
Revision & Date
1.6 – 03/24/2021
2 Bus+ Line
SAE-J1850 PWM and SAE-1850
VPW
3
Make/Model
Specific
Vendor Option
4 Chassis Ground Ground
5 Signal Ground Ground
6 Can High ISO 15765-4 and SAE-J2284
7 K line ISO 9141-2 and ISO 14230-4
8
Make/Model
Specific
Vendor Option
10 Bus- Line
SAE-J1850 PWM and SAE-1850
VPW
11
Make/Model
Specific
Vendor Option
14 Can Low ISO 15765-4 and SAE-J2284
15 L line ISO 9141-2 and ISO 14230-4
16 Battery Power Power
4. Getting Started
With any new platform, there are some changes in the form, fit, and function when compared to the
predecessor product line. This section highlights pertinent changes compared to the LMU32 platform
to help users get started with an EdgeCore device: