Product Info

Smart Module Series
SC200R Series Hardware Design
SC200R_Series_Hardware_Design 10 / 125
1
Introduction
This document, describing SC200R-WF module and its air and hardware interfaces connected to your
applications, informs you of the interface specifications, electrical and mechanical details, as well as other
related information of the module.
With the application notes and user guides provided separately, you can easily use SC200R-WF to design
and set up mobile applications.
Federal Communications Commission (FCC) Declaration of Conformity FCC Caution:
Any changes or modifications not expressly approved by the party responsible for compliance could void
the user’s authority to operate this equipment. This device complies with Part 15 of the FCC
Rules.Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause un-desired
operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules.These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equip-ment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help. Radiation Exposure Statement This
equipment complies with FCC radiation exposure limits set forth for an uncontrolled rolled environment.
This equipment should be installed and operated with minimum distance 20cm between the radiator and
your body.
Important Note：This radio module must not installed to co-locate and operating simultaneously with other
radios in host system except in accordance with FCC multi-transmitter product procedures. Additional
testing and equipment authorization may be required to operating simultaneously with other ra-dio. The
availability of some specific channels and/or operational frequency bands are country dependent and are
firmware programmed at the factory to match the intended destination. The firmware setting is not
accessible by the end user. The host product manufacturer is responsible for compliance to any other
FCC rules that apply to the host not covered by the modular transmitter grant of certification. The final
host product still requires Part 15 Subpart B compliance testing with the mod-ular transmitter installed.
The end user manual shall include all required regulatory information/warning as shown in this manual,