Service Guide
Table Of Contents
- Safety Information
- About the Document
- Contents
- Table Index
- Figure Index
- 1 Introduction
- 2 Product Overview
- 3 Operating Characteristics
- 4 Application Interfaces
- 5 Antenna Interfaces
- 6 Reliability, Radio, and Electrical Characteristics
- 7 Mechanical Information
- 8 Storage, Manufacturing, and Packaging
- 9 Appendix References
LTE Standard Module Series
EG915U_Series_Hardware_Design 18 / 90
2.5. Pin Description
The following tables show the pin definition of the module.
Table 5: I/O Parameters Definition
Table 6: Pin Description
evaluate whether the unstable output state on power-up meets your application design
requirements based on the specific usage scenario and circuit design.
Type
Description
AI
Analog Input
AO
Analog Output
AIO
Analog Input/Output
DI
Digital Input
DO
Digital Output
DIO
Digital Input/Output
OD
Open Drain
PI
Power Input
PO
Power Output
Power Supply
Pin Name
Pin No.
I/O
Description
DC Characteristics
Comment
VBAT_BB
32, 33
PI
Power supply for the
module’s baseband part
Vmax = 4.3 V
Vmin = 3.3 V
Vnom = 3.8 V
It must be
provided with
sufficient current
of 1 A at least.
VBAT_RF
52, 53
PI
Power supply for the
module’s RF part
It must be
provided with
sufficient current
up to 2.5 A.