Service Guide
Table Of Contents
- Safety Information
- About the Document
- Contents
- Contents
- Table Index
- Figure Index
- 1 Introduction
- 2 Product Overview
- 3 Application Interfaces
- 3.1. General Description
- 3.2. Pin Assignment
- 3.3. Pin Description
- 3.4. Operating Modes
- 3.5. Power Saving
- 3.6. Power Supply
- 3.7. Turn on/Turn off/Reset
- 3.8. (U)SIM Interfaces
- 3.9. USB Interface
- 3.10. UART Interfaces
- 3.11. SPI Interface
- 3.12. I2C Interfaces
- 3.13. PCM Interface
- 3.14. Analog Audio Interfaces
- 3.15. LCD Interface
- 3.16. Matrix Keyboard Interface
- 3.17. SD Card Interface
- 3.18. WLAN Application Interface*
- 3.19. ADC Interfaces
- 3.20. Network Status Indication
- 3.21. STATUS
- 3.22. Behaviors of MAIN_RI
- 3.23. USB_BOOT Interface
- 4 Antenna Interfaces
- 5 Electrical Characteristics, Radio and Reliability
- 6 Mechanical Information
- 7 Storage, Manufacturing & Packaging
- 8 Appendix References
LTE Standard Module Series
EC200U_Series_Hardware_Design 80 / 94
LTE-TDD B40 (10 MHz)
-99.4 dBm
-96.3 dBm
LTE-TDD B41 (10 MHz)
-98.9 dBm
-94.3 dBm
The GSM network access technology of EC200U-CN is optional. If the module that you select doesn’t
support GSM network access technology, there is no corresponding RF receiving sensitivity data.
Table 50: EC200U-EU Conducted RF Receiving Sensitivity
Frequency
Receiving Sensitivity (Typ.)
3GPP
Primary
GSM850
-109.5 dBm
-102.0 dBm
EGSM900
-109.5 dBm
-102.0 dBm
DCS1800
-109 dBm
-102.0 dBm
PCS1900
-109 dBm
-102.0 dBm
LTE-FDD B1 (10 MHz)
-97.8 dBm
-96.3 dBm
LTE-FDD B3 (10 MHz)
-98.5 dBm
-93.3 dBm
LTE-FDD B5 (10 MHz)
-99.2 dBm
-94.3 dBm
LTE-FDD B7 (10 MHz)
-97 dBm
-94.3 dBm
LTE-FDD B8 (10 MHz)
-98.7 dBm
-93.3 dBm
LTE-FDD B20 (10 MHz)
-98 dBm
-93.3 dBm
LTE-FDD B28 (10 MHz)
-98.8 dBm
-94.8 dBm
LTE-TDD B38 (10 MHz)
-98.3 dBm
-96.3 dBm
LTE-TDD B40 (10 MHz)
-98.5 dBm
-96.3 dBm
LTE-TDD B41 (10 MHz)
-98 dBm
-94.3 dBm
NOTE