Service Guide
Table Of Contents
- Safety Information
- About the Document
- Contents
- Contents
- Table Index
- Figure Index
- 1 Introduction
- 2 Product Overview
- 3 Application Interfaces
- 3.1. General Description
- 3.2. Pin Assignment
- 3.3. Pin Description
- 3.4. Operating Modes
- 3.5. Power Saving
- 3.6. Power Supply
- 3.7. Turn on/Turn off/Reset
- 3.8. (U)SIM Interfaces
- 3.9. USB Interface
- 3.10. UART Interfaces
- 3.11. SPI Interface
- 3.12. I2C Interfaces
- 3.13. PCM Interface
- 3.14. Analog Audio Interfaces
- 3.15. LCD Interface
- 3.16. Matrix Keyboard Interface
- 3.17. SD Card Interface
- 3.18. WLAN Application Interface*
- 3.19. ADC Interfaces
- 3.20. Network Status Indication
- 3.21. STATUS
- 3.22. Behaviors of MAIN_RI
- 3.23. USB_BOOT Interface
- 4 Antenna Interfaces
- 5 Electrical Characteristics, Radio and Reliability
- 6 Mechanical Information
- 7 Storage, Manufacturing & Packaging
- 8 Appendix References
LTE Standard Module Series
EC200U_Series_Hardware_Design 56 / 94
In addition, MAIN_RI behaviors can be configured flexibly. The default behaviors of the MAIN_RI are
shown as below.
Table 31: Behaviors of the MAIN_RI
The MAIN_RI behavior can be configured by AT+QCFG="urc/MAIN_RI/ring" and see document [2] for
details.
3.23. USB_BOOT Interface
The module provides a USB_BOOT pin. You can pull up USB_BOOT to 1.8 V before VDD_EXT is
powered up, and the module will enter download mode when it is powered on. In this mode, the module
can upgrade firmware over USB interface.
If your application has a scan key, you can also press the "USB_BOOT + KEYOUT0" scan key before
powering on the module, and the module will enter the download mode when it is turned on.
Table 32: Pin Definition of USB_BOOT Interface
The following figure shows a reference circuit of USB_BOOT interface.
The AT+QURCCFG allows you to set the main UART, USB AT port or USB modem port as the URC
output port. The USB AT port is used to send AT commands by default.
State
Response
Idle
MAIN_RI keeps at high level
URC
MAIN_RI outputs 120 ms low pulse when a new URC returns
Pin Name
Pin No.
I/O
Description
Comment
USB_BOOT
115
DI
Control pin for the module to
enter download mode
1.8 V power domain.
Active high.
The download control circuit must
be reserved.
NOTE