Service Guide

LTE Standard Module Series
EG91_Series_Hardware_Design
52
/ 105
3.13. SPI Interface
SPI interface of EG91 series module works as the master only. It provides a duplex, synchronous and
serial communication link with the peripheral devices. It is dedicated to one-to-one connection, without
chip selection. Its operation voltage is 1.8 V with clock rates up to 50 MHz.
The following table shows the pin definition of SPI interface.
Table 14: Pin Definition of SPI Interface
The following figure shows a reference design of SPI interface with peripherals.
Figure 25: Reference Circuit of SPI Interface with Peripherals
EG91 series provides 1.8 V SPI interface. A voltage-level translator should be used between the module
and the host if your application is equipped with a 3.3 V processor or device interface.
Pin Name Pin No. I/O Description Comment
SPI_CLK 26 DO SPI clock
1.8 V power domain.
If unused, keep it open.
SPI_MOSI 27 DO SPI master-out slave-in
SPI_MISO 28 DI SPI master-in slave-out
NOTE