Service Guide

LTE Standard Module Series
EG91_Series_Hardware_Design
20
/ 105
SMS
 Text and PDU modes
 Point-to-point MO and MT
 SMS cell broadcast
 SMS storage: ME by default
(U)SIM Interfaces  Support 1.8 V and 3.0 V (U)SIM cards
Audio Features

Support one digital audio interface: PCM interface

GSM: HR/FR/EFR/AMR/AMR-WB

WCDMA: AMR/AMR-WB

LTE: AMR/AMR-WB

Support echo cancellation and noise suppression
PCM Interface

Used for audio function with external codec

Support 16-bit linear data format

Support long frame synchronization and short frame synchronization

Support master and slave mode, but must be the master in long frame
synchronization
USB Interface
 Compliant with USB 2.0 specification (slave only); the data transfer
rate can reach up to 480 Mbps
 Used for AT command communication, data transmission, GNSS
NMEA sentences output, software debugging, firmware upgrade and
voice over USB
 Support USB serial drivers for: Windows 7/8/8.1/10, Linux 2.6–5.12,
Android 4.x–11.x, etc.
UART Interface
Main UART:

Used for AT command communication and data transmission

Baud rates reach up to 921600 bps, 115200 bps by default

Support RTS and CTS hardware flow control
Debug UART:

Used for Linux console and log output

115200 bps baud rate
SPI Interface

Provides a duplex, synchronous and serial communication link with the
peripheral devices.

Dedicated to one-to-one connection, without chip selection.

1.8 V operation voltage with clock rates up to 50 MHz.
Rx-diversity  Support LTE/WCDMA Rx-diversity
GNSS Features
 Protocol: NMEA 0183
 Data update rate: 1 Hz by default
AT Commands
 Compliant with 3GPP TS 27.007 and 3GPP TS 27.005
 Quectel enhanced AT commands
Network Indication  NETLIGHT pin for network activity status indication
Antenna Interfaces

Main antenna interface (ANT_MAIN),